Sandblasting hose It has a very critical effect in the manufacturing industry, in which the adhesive plus carbon black can reasonably eliminate static electricity, immediately contact with air compression and wear-resistant materials, and has very high regulations on wear-resistance. Once worn, the improved layer will be exposed, and the sand blasting treatment pipe will crack.

The improvement layer of sandblasting hose is a compressive layer, so the raw materials and reasonable layout of the improvement layer immediately determine the compressive level of sandblasting plastic hose. Generally, there are two kinds of raising layers: cloth clip raising layer and surrounding raising layer. Most of the sandblasting plastic hoses with an inner diameter of 50 mm or more are used in the construction site where the sandblasting pipe is required to be connected, so as to reduce the loss of working pressure in the sandblasting plastic hose and ensure the normal construction of the shot blasting carding project.

The characteristics of the improved layer of the sandblasting hose are also very prominent. Polyurethane materials and butyl rubber are selected as the key raw materials for the rubber in the sandblasting hose, and the special reinforcement agent is registered. The inner glue of the finished product is light yellow and transparent, and has the characteristics of super wear resistance, high wear resistance, high pressure resistance, etc. The overall goal of wear resistance is 2-3 times that of ordinary sandblasting hose, which shows that its characteristics are very excellent.

The high quality of the goods and machinery used by everyone will inevitably lead to many common failures in the whole process of their application, which will more or less cause certain harm to everyone's work. Just like the application of sandblasting hose, there are marks on the surface of the adhesive seam, difficulties need to be solved.

1： The applied water cloth shall be applied according to the original tight and loose edges of the water cloth when it is reapplied.

2： Release sufficient and uniform working pressure to the pipe body when people wrap water cloth around the lap joint of sandblasting hose.

3： According to winding Sandblasting hose The water cloth with different overall width shall be used for the size of diameter (for rubber hose with diameter below 30mm, the overall width of the water cloth shall not exceed 90mm), and the overall overlapping width of the water cloth shall be 3/5-2/3 of the overall width of the water cloth.

4： Check the tap water cloth prepared for application in advance, without tight edge condition.

5： Keep the working temperature of the work area above 18 ℃.