Now Sandblasting pipe It has been used in more and more places. During the use of sand blasting pipe, it is likely to be scratched due to improper use or during installation, removal and movement. So how can we avoid abrasion of the sandblasting pipe when we use it? The following is a summary of our experience in using sandblasting tubes at ordinary times, hoping to help you.
1. When the sandblasting pipe is stored, do not put the sandblasting pipe directly on the ground. Some protective measures should be taken for the sandblasting pipe, such as using some objects to block it. When using the sandblasting pipe, do not drag the sandblasting pipe directly on the ground, because there may be a lot of debris or hard objects on the ground, and the sandblasting pipe will rub with them when dragging, resulting in scratches.
2. Any end face of the sandblasting pipe shall not directly contact with other hard objects, which is something we should pay attention to in daily use. Because the sandblasting pipe is made of high-quality raw materials, direct contact with hard objects may lead to wear.
3. When stacking sandblasting pipes, we should store them properly. Sand blasting pipes shall not be placed randomly. The interval work of sand blasting pipes shall be well done, and the sand blasting pipes shall be stored separately. This can not only prevent procrastination, but also facilitate sales and shipment.
4. The storage place of sand blasting pipe shall be cleaned, and there shall be no hard objects and sharp objects such as glass. Prevent the abrasivejet pipe from contacting with these objects and scratching the abrasivejet pipe.
5. The disassembly and repair process of sand blasting pipe must be standardized and executed according to the correct method. Be careful not to contact with any hard objects during operation. It is also easy to cause scratches.
Sandblasting pipe It is a consumable, so we should pay attention to the above points of sandblasting pipe no matter in the process of transportation, storage and installation. Only in this way can we effectively reduce the abrasion of sand blasting pipe and save our engineering cost.