Sandblasting hose The use effect of sand blasting hose is not only related to quality, but also affected by the correct connection and use method of sand blasting hose. The following section will take you to know what problems you need to pay attention to in the assembly of sandblasting hose.

Special attention shall be paid to the sandblasting hose before installation. The sandblasting hose is often cracked, and the sandblasting hose shall be knocked with a wooden hammer to see if there is a mute sound. If the sand blasting hose is found to have cracks and mute sound, installation and application are prohibited. Also, the main operator of sandblasting hose lathe should be checked Whether the axial rotation speed ratio is consistent with the application rate of large sandblasting hose when marking the inner hole of sandblasting hose.

When tightening the sand blasting hose, only the special manual nut wrench is allowed to be used for the sand blasting hose, and it is forbidden to use the filling fixture or knock the special tool. In addition, when tightening, pay attention to the tightness level of the nut or screw, and it is appropriate to clamp it to a level that is sufficient to push the sandblasting hose without causing the sliding drive force, so as to avoid damage to the sandblasting hose caused by excessive clamping force of the sandblasting hose.

The sandblasting hose connector and hose fastening method: the sandblasting hose is stripped and the external rubber is buckled: the sandblasting hose needs to be stripped of an appropriate length of external rubber layer, and the sandblasting hose is applicable to GB/T3683-92, GB/T10544-03, DIN2002, SAE100R1A/R2A and other specifications of steel wire manually woven hose and steel wire coiled hose.

Peel and buckle the inner and outer rubber of sandblasting hose: the sandblasting hose is required to strip off the inner and outer rubber layers of appropriate length. The sandblasting hose is called the internal locking sandblasting hose type buckle type hose connector, which is applicable to GB/T10544-89 large-diameter pipe SAER12, DIN20023-4SH and other high-pressure steel wire coiled sandblasting hose.

The sandblasting hose does not peel off the outer glue and buckle: the manufacturing process of the sandblasting hose connector is simple, and it is suitable for chemical fiber manual braided hose, sandblasting hose and other models and specifications of steel wire manual braided hose.

The sandblasting hose is composed of various connections common in the sales market, and the sealing method is carefully customized. The sandblasting hose has the advantages of high-quality sandblasting hose, low price, reasonable structure, and convenient use.

This is all about the connection of sandblasting hose joint and hose. I hope it will be helpful to you.